Hi again,
I’m still trying to find the solution…
FTDI drivers installed correctly, also checked with HTerm if there is data transmission–> OK
Running your o323BGCTool I perform the „Flash Firmware“, selecting v1.31 board, latest firmware version (I’ve also tried the previous ones…), checking the full chip erase. Before pressing Flash button, I enter boot loader mode pressing and releasing reset while boot is pressed, leds turn off except for the yellow one (BT).
The DOS window shows correctly how the chip is erased, how the new firmware is flashed, and the verification also shows that everything is OK. Then, the device is reseted and the leds start blinking again. Everything seems to be running as it should.
Then, I try to READ or CONNECT, but it says:
Connecting…please wait!
v…
Read…ABORTED!
Please do a first read to get controller settings!
I have the correct COM port selected, I’ve tried supplying the board from battery and from USB, different cables… I don’t know where I’m missing something or what I’m doing wrong…
Any hints for solving the problem? I’ve red many pages on the forums and the wiki but can’t find the solution…
Thanks in advance!!!
Ibai