Von: Horst
Hallo Olliw, ich benutze den Storm32 v1.3, firmware 0.96. und möchte ihn über UART1 ansprechen (RC pins). Mein Skript dazu funktioniert einwandfrei, das habe ich mit einen anderen Microcontroller...
View ArticleVon: Burak
Hi Olliw, What do you mean „DEPRECATED“? Nor for sale? 12. Jan. 2017: New board STorM32-BGC v2.4 released, specifically designed for NT
View ArticleVon: RabeBiker
Hallo Olli. Ich habe seit kurzem das gleiche Problem wie hier beschrieben. Wenn ich das Board per USB an den PC anschließe, dann steht nach dem Connect in der GUI: „IMU is not available“, „IMU: None“....
View ArticleVon: OlliW
das kann sein dass das Board kaput ist, aber in den allermeisten Fällen liegt das daran dass einfach irgendetwas (triviales) falsch gemacht wurde. Das Wiki hilft dabei. Ansonsten gibt’s den rcgroups...
View ArticleVon: OlliW
Als Antwort auf Gapey. yes, it seems possible, and I’m attempting it issue remains however to get hands on NT motor modules, so except of size not much gained for further discussion pl go to the...
View ArticleVon: DavidB
Guten Abend OlliW, Folgendes Problem tritt auf: Wenn das Gimbal Level möchte klappen alle Achsen zügig, außer die Roll Achse, sie bewegt sich 15 Grad nach rechts und wieder zurück, periodisch… Ich habe...
View ArticleVon: Gapey
Hi olliw, Is it possible to compile the firmware for using CC3D (CC3D atom) as a main controller in the NT system ??? Buy CC3D is easier and cheaper than the controller v2.4. The motor driver on the...
View Article